How many holes recorder

Write your answer Related questions. How many holes does a recorder have if it is a factor of 32? How many holes does a recorder have? How many finger holes does a recorder have? How many holes do you put on for a recorder with e? What are the holes on a recorder called? How many fingers are on F for recorder? How many holes does a recorder have if it is a factor of 28? How many holes for b on a recorder? What are the holes on the recorder?

What are the holes called on a recorder? What do the holes stand for in the recorder? What are the extra holes at the bottom of your recorder? What is c and f on recorder? Were is c on a recorder? Notes on the recorder? How many holes do you have to cover for the note d on the recorder? How does a recorder make a sound?

How do you play an A on the recorder? What is a E on the recorder? In other words a different place for your fingers that you either cover a hole directly or push a key which covers a hole or a combination of holes. So what are all these buttons and holes for?

The concert flute and particular has several buttons that you may go through a song without pushing down but instead they have very particular purposes, such as for trilling. This is a terribly confusing topic. I did the hunting for you:. Just a note ba doom psh , a student flute can have a B foot joint, as well.. The key flutes are typically flutes that have a B Foot Joint.

The B foot joint is a longer foot joint than the C foot joint and most often but not always especially on older flutes features an extra key called the Gizmo Key. The gizmo key is a paddle on the lowest section of the flute the foot joint that gives the flute player access to a more stable 4th octave C source on a flute with a B foot joint.

The flute has very complex fingerings in comparison to many instruments—another complexity that is found on some flutes is the C trill key. Some members of the upper class even tried their own hand at the recorder.

It then became a popular amateur instrument among the middle class as well. During the 17 th century, or early Baroque period , recorders were constructed in three parts, called joints: the head, middle, and foot.

The middle section had 7 finger-holes while the foot had only one. After , the popularity of the recorder declined and it was not often found in musical repertoire. However, the turn of the 20th century brought a revival of the instrument in a variety of different musical styles ranging from avant-garde and theatrical to minimalist and microtonal.

Several attempts have been made to modernize the structure of the recorder. If you look closely at a recorder, you will see that the size of the holes varies.

The locations of the holes and their alignment with the interior shape of the bore have been developed through over years of trial and error, with the aim of producing tones at different pitch intervals. To this end, a variety of approaches have been used. For example, for the double holes, where there are two open holes in one place, the combined surface area of both holes is the same as the surface area of a single hole for a single tone.

Also, when holding in the instrument, if only the hole on the right is covered a note at a semitone interval is produced, but if both of the holes were made to be exactly the same size, the interval produced would not be a semitone.

The lower two double holes, covered by the little finger and ring finger of the right hand, also may appear at first glance to be the same size, but if you look closely you will see that they are actually different sizes. The tone holes of a recorder tend to be thought of as being positioned at regular intervals, but that is not actually the case. They are not at regular intervals, nor are they all positioned in a straight line.

The holes are not in a straight line because they are positioned so as to be easier to cover with the fingers.